Plant Diseases

You Are Here: Home / Archives / Category / Plant Diseases

Powdery Mildew


Powdery Mildew

This is a fungal disease that appears as a white, powdery coating on the surface of the leaves. Poor air circulation and high humidity conditions may increase the problem. Powdery mildew doesn’t usually kill a plant, but it is unattractive and my cause distortion of the leaves or premature leaf drop. It will however interfere with photosynthesis by covering the surface area of the leaves. This can weaken the plant overall and make more susceptible to other diseases or add complications to an existing problem, such as insect or environmental issues.


Increase air circulation if possible and remove infected leaves. Spray with sulphur. If outdoors copper sulphate may be applied instead of sulphur.

Powdery Mildew

Sooty Mold


Sooty Mold:

This is a black fungus that grows on the sticky honeydew deposited on the foliage by various sucking insects such as aphids, scale and mealybugs. The mold is unattractive and may interfere with photosynthesis by blocking sunlight.


Treat insects causing sticky honeydew. Wipe off affected leaves with a damp cloth.

Sooty Mold




This is a fungus which appears as powdery orange spots on the underside of leaves. Infected leaves may drop prematurely.


As for any fungus, improve air circulation if possible. Remove infected leaves and spray with sulphur.

Rust Fungus

Black Spot


Black Spot

These are round, black spots on leaves usually occurring during humid or wet weather.
There may be yellowing of the leaves, followed by premature leaf drop.  Black spot also weakens the tree overall by reducing the area that it can take in sunlight through photosynthesis. Black Spot will rarely kill a tree but it can severely weaken the tree and make it more susceptible to other diseases.


Increase air circulation if possible and remove infected leaves. Watering should be done early in the day so that the leaves are not wet overnight. Drenching the soil, being careful not to splash water on the foliage.Spray with sulphur or Bordo.

Black Spot

Cedar Apple Rust


Cedar Apple Rust:

This is a disease that requires two hosts, apple/crabapple and eastern red cedar/junipers. It cannot spread from crabapple to crabapple, or from cedar to cedar, it alternates between the two. In spring spores from orange galls on cedars or junipers are blown to apple trees, as far as 2-3 miles away. These spores germinate during warm, wet weather, and they infect the leaves and fruit. Yellow spots appear on the leaves, gradually enlarging and turning orange, and causing premature leaf and fruit drop. In the summer small cups with fringed edges develop on the undersides of the leaves. These spores are blown back to cedars and junipers, causing new infections.


Where possible, avoid planting these two hosts within several hundred yards of each other. Remove any galls and destroy them. If cedar-apple rust is diagnosed on the leaves, it is too late to treat them. Early season fungicide applications, repeated at 7-10 day intervals may be effective.

Cedar Apple Rust Cedar Apple Rust

Fire Blight


Fire blight:

This is a bacterial disease that is a problem for trees in the Roseaceae family such as apple, crabapple, pear and mountain ash. The leaves and branches become blackened and look as though they have been burnt, and terminal branches bend over like a shepherd’s hook. Clear yellow liquid may ooze from infected branches. The disease can be spread by rain or wind, insects or by infected pruning tools.



There is no chemical control for Fireblight. Pruning infected wood may slow down the disease, but it may also create more problems if not done properly. Pruning tools must be disinfected after each cut with diluted bleach to remove all traces of the disease. All cuts should be made at least 10” (25 cm) into healthy wood. Copper or sulphur sprays may be used, but effectiveness is questionable.


Fire BlightFire Blight  Fire Blight

Black Knot


Black Knot:

This is a disease that most commonly affects plum and cherry trees. Greenish swellings form on twigs and branches, in time these develop into black, cylindrical corky galls which will kill the infected part. Black knot spreads more quickly during warm, wet springs.



There is no chemical control for black knot. Prune infected branches late winter, cutting at least 4 inches beyond the infected area and spray with dormant oil. Sterilize pruning equipment with dilute bleach in between cuts. Repeat applications of fungicide every 7-10 days. This may help to slow down the spread of the disease.


Black Knot

Verticillium Wilt


Verticillium Wilt of Trees and Shrubs

Cynthia L. Ash


Copyright ©  2012  Regents of the University of Minnesota. All rights reserved.

Verticillium wilt is caused by the soil-borne fungi, Verticillium albo-atrum and Verticillium dahliae. However, V. dahliae is the species that most commonly attacks woody ornamentals in the United States.

Verticillium is common in many soils and affects several hundred herbaceous and woody plant species, while exhibiting definite host preferences (see table 1). In Minnesota, ash, catalpa, maple and Russian olive are most frequently infected. This disease can become a serious problem on susceptible hosts in infested soils, since the fungus persists in the soil indefinitely, many times on hosts that exhibit no symptoms.

Table 1. Trees and shrubs susceptible to Verticillium

Barberry, JapaneseElmRose
Boxwood, KoreanHoneysuckleRussian olive
Buckeye, OhioLilacServiceberry*
CatalpaLinden*Smoke tree
Cherry, other stone fruitsLocust, blackSpirea
Coffee tree, KentuckyMagnoliaSumac
Cork treeMapleViburnum
Currant and gooseberryOak, pin and red (rare)Wigela
*Some plant species are listed in both tables (linden, dogwood).
The resistance or susceptibility will depend on the cultivar and the strain of Verticillium present in the soils.

Because of its ability to spread internally or systemically within the plant and to kill the plant, Verticillium wilt is considered a serious disease. However, compared with a wilt disease such as Dutch elm disease, Verticillium is less severe. Natural stands or forested areas are rarely affected by Verticillium wilt. Verticillium wilt is often confused with other diseases or abiotic conditions. Herbicide damage, adverse environmental conditions and mechanical damage may cause the same or similar symptoms.

Symptoms caused by Verticillium develop anytime during the growing season, but are most apt to appear in July and August. In some cases the symptoms may be more severe during or following cool weather. Symptoms appear chronically, or they may be acute and often lethal. Chronic symptoms include small, yellow foliage, leaf scorch (marginal browning), slow growth, abnormally heavy seed crops and dieback of shoots and branches. Often, the foliage on one or more branches wilts suddenly. Acute symptoms include leaf curling, drying, an abnormal red or yellow color of leaves or areas between leaf veins, partial defoliation, wilting and branch dieback. Often one branch or one side or sector of the plant is affected. Recurrence of wilt in ensuing years is unpredictable, as is its severity. In its lethal form, Verticillium wilt will cause a sudden and total collapse of the plant.

Verticillium Wilt figure 1

Figure 1. On small trees wilting, leaf scorch and defoliation can occur quickly on a large portion of the tree, as indicated by the circle.

Verticillium Wilt figure 2

Figure 2. Yellowing of the foliage may precede wilting.

Verticillium Wilt figure 3

Figure 3. Discoloration in the annual growth rings is a symptom of Verticillium wilt.

Some tree species exhibit elongate, dead areas of bark on diseased branches or trunks where the inner bark is killed. Other species, such as green ash, tend to drop green leaves before noticeable yellowing, scorching or wilting has occurred.

Streaking of the vascular tissue or wood may accompany external symptoms. This discoloration may be absent during the early stages of infection and only occasionally develops in some species such as ash, Fraxinus species. The streaking may be scattered throughout a branch or trunk cross-section if the plant is chronically infected, or it may be confined to new sapwood, indicating a new infection. Examination of a cross-section of a larger branch or trunk will often reveal the disease history of a tree. Peeling back the bark of wilting branches may reveal streaked sapwood if the discoloration has spread up into the smaller branches. The actual color of the streaking is dependent upon the host. In maple, Acer species, the discoloration tends to be greenish brown, but colors range from gray-green to brown or black.

Verticillium invades the root system directly or through wounds caused naturally by root growth through the soil or soil organisms. Once in plant tissues, the fungus produces toxins and invades the xylem (water conducting tissues), moving upward in the plant via spores. Where new spores lodge in the vascular tissue a new infection begins. Toxins produced by Verticillium may kill plant cells at some distance from those directly invaded. Thus, the fungus often cannot be isolated from the apex of streaked wood or from wilting branches, even though damage is apparent there (figure 4).

In response to invasion by the pathogen, the host produces substances called tyloses or gums that attempt to close off the invaded cells to limit fungal movement in the plant. This shutting down of infected vascular tissues reduces the flow of water from the roots upward. At this point, reduced water flow and toxins often result in external symptoms.

In maple, the Verticillium fungus progresses around a growth ring by a combination of upward spread and tangential growth. If the pathogen fails to cross from one season’s wood to the next, the result is remission of acute symptoms and compartmentalization (containment) of the diseased wood. The severity of chronic symptoms depends upon the extent of root and old wood damage. Acute symptoms that recur after one year or more of remission indicate a new infection moving up from the roots. Trees showing general and severe wilt cannot be saved and should be replaced with a nonsusceptible species.

The fungus survives saprophytically in the soil as thread-like growths called mycelia and/or minute black resting structures called microsclerotia. In some plants the fungus may move into the leaves and persist as mycelia or microsclerotia when the leaves fall to the ground. Microsclerotia are capable of persisting for 10 or more years in the soil without a host plant. However, warm, waterlogged soils result in the rapid death of microsclerotia.

Nursery crops on land formerly used for susceptible vegetable or fruit crops are at high risk of infection. Plants from such nurseries may develop wilt after they are transplanted to landscapes. In addition, microsclerotia may form on and within the roots of plants that are resistant, but not immune, to infection and that exhibit no above-ground symptoms. This perpetuates the fungus and results in the introduction of Verticillium into uncolonized soils via infected plant material including seeds, cuttings, transplants, tubers, scions, buds and bare root trees. Infested soil on plants and equipment also spread the disease.

 Verticillium Wilt figure 4Figure 4. Discoloration of the xylem (sapwood) is the most apparent near the base of the tree due to root infection. Streaking in small branches (less than 2 inch diameter) is uncommon. Dieback in the crown is due to damage occurring in the roots, trunk and larger limbs. Verticillium Wilt figure 5Figure 5. Verticillium wilt typically causes the margins of leaves to turn brown giving the leaf a scorched appearance.
 Verticillium Wilt figure 6Figure 6. Cross-section of a tree trunk. The wood composed of xylem layed down in the form of annual rings.


Managing trees infected with Verticillium wilt will take time and knowledge. First, confirm that the symptoms are indeed caused by Verticillium wilt. The presence of typical symptoms and streaking of the vascular tissue is fairly diagnostic, but a laboratory culture test should be run to confirm the diagnosis.

Fungicides will not cure infected trees. Soil fumigants, if available, may be used for small amounts of garden or greenhouse soil before replanting, but are generally not feasible in landscapes.

The severity of disease development will depend on the strain of the pathogen, the level of susceptibility in the host, and environmental factors. Landscape trees with recent wilt symptoms should not be removed immediately. They may “recover” and perform fairly well with some environmental manipulation. In general, the most resistant plants are those grown in moderately fertile soil in which the balance of major nutrients is tipped slightly toward high potassium and low nitrogen. Generously watered plants are often invaded less extensively than those under moderate to severe water stress.

When replacing trees in areas where Verticillium is present in the soil, select resistant or immune trees (Table 2). Fertilize properly to promote vigorous growth and water regularly during the growing season. Remove dead and weak branches. This does not remove the fungus from the tree, but prevents infection by other fungi. DO NOT use the chipped wood as a mulch unless it is properly heated in a compost pile.

Table 2. Trees and shrubs resistant or immune to Verticillium

AppleHawthornOak, white and bur
GinkgoMountain ashWalnut
*Some plant species are listed in both tables (linden, dogwood).
The resistance or susceptibility will depend on the cultivar and the strain of Verticillium present in the soils.



Commercial Turf

We also specialize in commercial turf for golf courses. To visit our commercial turf site please click here.

4D Agro Link

4D Agro is a software modeling service that provides continuous monitoring to help farmers and golf courses manage the nutrients in the soils. To learn more click here.